Skip to main content
Connect Deel with a scoped personal access token to sync your workforce roster and IT assets, and run access reviews. Read-only — payroll, immigration, benefits and compensation are never read.
Read-only access. DSALTA only reads data from this integration. It never creates, modifies, or deletes anything in your environment, and every remediation step is performed by your team directly in the third-party product.
DSALTA collects this integration’s data when you connect it — you can refresh it at any time with Sync from integrations on the Integrations page. The compliance checks below re-run once a day at 02:00 America/New_York.

​
What DSALTA reads

DSALTA reads your Deel workforce roster — full name, primary email address, hiring type (contractor, EOR, PEO, HRIS direct employee or direct employee) as the role, worker status and creation date — which appears on your Access page; and your Deel IT assets — brand and product name, serial number, category, condition grade, status, location and the email of the person the asset is assigned to — which appear on your Inventory page. Workers whose Deel status is OFFBOARDING, INACTIVE or NOT_STARTED are recorded as Inactive and everyone else as Active, and MFA reads Unknown because Deel’s people record carries no MFA field. Deel publishes no audit-log endpoint, so Incidents and Changes are not populated from Deel.It calls these Deel endpoints:
  • /rest/v2/organizations
  • /rest/v2/people
  • /rest/it/assets
Every request is a read. DSALTA has no code path that creates, modifies, or deletes anything in your Deel environment.

​
Troubleshooting

Invalid token, or a token scoped to a single contract. An Organization token with the organizations:read scope is required.
The token is missing the it-assets:read scope. Recreate it with that scope, then disconnect and connect Deel again.
Open Integrations in the DSALTA sidebar, stay on the Connected tab, and click Manage on the integration’s card. Open the Status tab: it shows either Connected and working properly or Connection issues detected.Use the Status tab, not Overview — Overview always reports Connected regardless of the real state.
On an integration-powered check, Failed normally means DSALTA was blocked rather than that you are non-compliant. Open the test, go to Source Data, and read the result code: 403 is a missing permission, 428 is a setting DSALTA still needs, 500 is a failure on DSALTA’s side.A real compliance gap shows 207 and leaves the test looking Completed. See Understanding Test Results.
Compliance checks re-run once a day at 02:00 America/New_York. To refresh sooner, open Integrations → Connected and click Sync from integrations at the top right — it refreshes every connected integration at once.
There is no Reconnect, Repair or Refresh Token button. The only repair available is to disconnect and connect again.
Disconnecting is destructive and cannot be undone. DSALTA removes the access records, inventory, vulnerabilities, code changes, incidents and device records collected from this integration, and deletes the test results tied to the connection. Export anything you still need as audit evidence first — see Integration errors.
That is expected. Configure scope is read-only — it shows what DSALTA is permitted to read, and has no Save action. To change what DSALTA can see, change the permissions on the credential in the third-party product, then disconnect and connect again.